Application of low-cost UAV integrated with air quality monitoring sensors and artificial neural networks to simulate air pollution at a stone quarry

- Authors: My Chi Vo1*, Truc Kim Kieu1, Long Quoc Nguyen2, Huy Dinh Nguyen3
Affiliations:
1 Vietnam Mining Science and Technology Association, 226 Le Duan, Ha Noi, Vietnam
2 Hanoi University of Mining and Geology, 18 Vien St., Ha Noi, Vietnam
3 Hanoi University of Civil Engineering, 55 Giai Phong, Ha Noi, Viet Nam
- *Corresponding:This email address is being protected from spambots. You need JavaScript enabled to view it.
- Keywords: Sensor network, air quality monitoring, unmanned aerial vehicles, open-pit mine/stone quarries, neural network creation.
- Received: 10th-Aug-2024
- Revised: 5th-Nov-2024
- Accepted: 10th-Nov-2024
- Online: 1st-Aug-2025
Abstract:
This paper evaluates the application of low-cost unmanned aerial vehicles (UAVs) with integrated air quality monitoring sensors UMS-AM in environmental monitoring and assessment in construction-stone mining areas and predicting the density of components using multi-layer artificial neural networks (MLP Neural Nets). To achieve these goals, DJI Inspire 2 drones equipped with PM1.0, PM2.5 and PM10 fine dust sensors were used for experimental measurements at two stone quarries Tan My and Thuong Tan in Binh Duong province. In addition, MLP Neural Nets were used to predict the density of air components in the stone quarries when the production process is expanded with deep mining modules and larger modules in the future. Finally, 3D simulation models of PM1.0, PM2.5 and PM10 indexes were built. The results of the study show that low-cost dust monitoring in quarry areas using UAVs is completely feasible and should be considered for application in other open-pit mines, contributing positively and effectively to the control of greenhouse gas emissions in open-pit mining areas.

[1]. Alvarado, Miguel et al. (2015). "Towards the Development of a Low Cost Airborne Sensing System to Monitor Dust Particles after Blasting at Open-Pit Mine Sites", Sensors. 15(8), tr. 19667.
[2]. Cárdenas, Andrés M et al. (2018), "Pollution-and-greenhouse gases measurement system", Measurement. 129, tr. 565-568.
[3]. Cryderman, Chris, Mah, S. Bill and Shufletoski, Aaron (2014), "Evaluation of UAV Photogrammetric Accuracy for Mapping and Earthworks Computations", GEOMATICA. 68(4), tr. 309-317.
[4]. Haidari, Leila A. et al. (2016), "The economic and operational value of using drones to transport vaccines", Vaccine. 34(34), tr. 4062-4067.
[5]. Khan, Muhammad Arsalan et al. (2017), "UAV-Based Traffic Analysis: A Universal Guiding Framework Based on Literature Survey", Transportation Research Procedia. 22, tr. 541-550.
[6]. Lee, S. và Choi, Y. (2015), "On-site demonstration of topographic surveying techniques at open-pit mines using a fixed-wing unmanned aerial vehicle (drone)", Tunnel & Underground Space. 25, tr. 527-533.
[7]. Madokoro, Hirokazu et al. (2021), "Development of drone-mounted multiple sensing system with advanced mobility for in situ atmospheric measurement: A case study focusing on PM2. 5 local distribution", Sensors. 21(14), tr. 4881.
[8]. Masoud, Sara et al. (2021), "A Sensor-Based Data Driven Framework to Investigate PM 2.5 in the Greater Detroit Area", IEEE Sensors Journal. 21(14), tr. 16192-16200.
[9]. Mourato, Sandra et al. (2017), Improving a DSM Obtained by Unmanned Aerial Vehicles for Flood Modelling, IOP Conf. Series: Earth and Environmental Science, IOP Publishing.
[10]. Nguyen, L. Q. et al. (2020), "3D spatial interpolation methods for open-pit mining air quality with data acquired by small UAV based monitoring system", Inżynieria Mineralna.
[11]. Nguyen, Quoc Long et al. (2020), "3D spatial interpolation methods for open-pit mining air quality with data acquired by small UAV based monitoring system", Inżynieria Mineralna. 1(2), tr. 263-272.
[12]. Olivares, Víctor et al. (2015), "Modeling Internal Logistics by Using Drones on the Stage of Assembly of Products", Procedia Computer Science. 55, tr. 1240-1249.
[13]. Sarmad, Muhammad, Ruspini, Leonardo Ca`rlos and Lindseth, Frank (2023), "SIT-SR 3D: Self-supervised slice interpolation via transfer learning for 3D volume super-resolution", Pattern Recognition Letters. 166, tr. 97-104.
Other articles